12 - Installation manual - Ecotype
C
C
h
h
a
a
p
p
t
t
e
e
r
r
3
3
T
HE
E
COTYPE
C
OVERING
S
YSTEM INSTALLATION
IMPORTANT!
Before starting the installation process, check the covering model at your disposal and examine
carefully any particular case that can occur.
3.1 Fitting the rear pulleys - Hand-operated version for body < 8 m
3.1.1
Fitting the rear pulleys in case of “STANDARD CABLE SYSTEM”
The installation of the rear pulleys requires a special attention in order to avoid to create any obstacle for mobile elements
(i.e. tailgate with lateral opening system).
The best installation position for the plate is the one as close as possible to the rear edge, but at a sufficient distance f or
avoiding to be an obstacle for hinges.
WARNING!
A wrong positioning of the pulleys could cause damages for the covering or for the tipper body.
If in doubt, carry out mobility trials of the rear mobile elements to avoid unpleasant surprises.
•
For a proper working of the covering system the axis of the lower fastening hole of the
pulley has to be positioned at a distance of 35 mm from the upper edge of the tipper
body.
•
Drill a M12 threaded hole on the lateral board wall, aligning it with the pulley hole.
•
Fasten the pulley and U-bolt with the hexagon head screw M12x60 supplied with the
system.
•
SECTION A-A
Note:
During its working life the structure is subject to vibrations and stress; therefore, it is recommended to apply a medium
or strong threadlocker Loctite
®
liquid.
•
Repeat now the pulley fastening operation on the opposite board wall.
Note:
The proper fitting of the rear pulleys is of primary importance since it is binding for the positioning of all the
subsequent element.
3.1.2
Fitting of the rear pulleys in case of “LOWERED CABLE SYSTEM”
For installing the LOWERED CABLE covering system the
height indication of 35 mm given for installing the standard
cable covering system has to be increased by 33 mm.
The installing height
for lowered cable system becomes 68
mm
➔
