1900076 REV.1
Page 1 of 4
OPERATING AND MAINTANANCE INSTRUCTIONS
FILTRO
Auto-Fill Jug, Flask & Mini-Flask Versions
-
P/N: (Jug) 1000617 ; (Flask) 1000618;
-
(Jug - Dual Hot plate) 1000619; (Mini-flask) 1000622
INTRODUCTION
The information provided in this manual is intended to assist in the installation and
maintenance of the Auto-Fill Filtro Filter coffee Brewer. Please read the instructions
carefully to prevent accidents and ensure an efficient installation.
This manual is not a substitute for any safety instructions or technical data affixed to the
machine or its packaging. All information in this manual is current at the time of
publication and is subject to change without notice.
Only technicians or authorised service providers should carry out maintenance of these
machines.
The company accepts no responsibility for any damage or injury caused by incorrect or
unreasonable installation and operation.
SAFETY INSTRUCTIONS
·
Read and keep these instructions.
·
To protect against electric shock do not immerse mains cord in water or other
liquid.
·
To prevent chafing of the cable, do not let the mains cord hang over the edge of a
table or counter; or touch hot surfaces.
·
Do not operate any product with a damaged cord, plugs, or after the machine
malfunctions or has been damaged in any manner. If the supply cord is damaged,
it must be replaced by the manufacturer or approved service agent in order to
avoid a hazard.
·
Switch off at the mains (unplug or disconnect from outlet). Allow to cool before
removing components.
·
The use of non-approved spares and/or accessories may cause damage and/or
injuries.
·
Do not use outdoors.
·
Do not use the product for anything other than its intended use.
·
Keep the outside of the coffee maker clean and dry at all times.
DURING OPERATION
!
Allow time for all the coffee to drain from the filter bowl before removing.
!
Protect the controls against grease and dirt.
!
Never use warm or hot water to fill the machine.
!
Risk of scalding. Beware of removing the filter basket/jug/flask when the
brewer is in operation. ALL users of this machine should be trained and should
be aware that the machine dispenses very hot beverages.
!
Do not place an empty glass jug on a hotplate when it is switched on except
immediately before brewing.
