8716P Hybrid NVR Installation Guide
31
Unit Setup
Installing Hard Drives
This section describes how to install a Serial ATA (SATA) hard drive, or install additional drives (up
to two).
WARNING:
The procedures contained in this section outline how to install components located inside the
unit, requiring the removal of the cover. These procedures are to be performed by qualified service
personnel only. When working inside the unit, ensure you take anti-static precautions.
Do not operate the unit with the cover off.
ATTENTION :
Les procédures contenues dans cette section décrivent comment installer les composants
situés à l'intérieur de l'unité, nécessitant le retrait du couvercle. Ces procédures doivent être effectuées
uniquement par du personnel de service qualifié. Lorsque vous travaillez à l'intérieur de l'appareil,
assurez-vous de prendre des précautions antistatiques. N'utilisez pas l'appareil avec le couvercle retiré.
Installation Requirements
The following are included in the packaging with the recorder:
•
8 screws, four (4) for each hard drive (used to secure the hard drive to the bracket)
•
two (2) data cables, one for each hard drive (attached to PCBA)
•
two (2) power cables, one for each hard drive (attached to PCBA)
To install one or more hard drives
1
Unplug the unit and wait for the LEDs to turn off.
2
Remove the three (3) screws from the cover of the recorder.
Note:
Set these screws aside - you will use them to re-attach the cover.
Screws
