8516 Hybrid NVR with RAID Installation Guide
34
Unit Setup
3
Install the upper mounting screws at the marked locations.
•
If the upper mounting location is in a wall stud, thread the screw directly into the wall stud.
•
If the location is in drywall, first install a drywall anchor, then thread the screw into the anchor.
Do not thread the mounting screws all the way in. The screw heads should protrude approximately
0.25 inches (0.64 centimeters) from the mounting surface so that you can hang the recorder on them.
4
Lift up the recorder and hang it on the upper mounting screws. Do not tighten the screws at
this time.
5
Mark the locations of the two lower mounting holes.
6
Remove the recorder from the mounting screws and put it aside.
7
Install the lower mounting screws at the marked locations.
•
If the lower mounting location is in a wall stud, thread the screw directly into the wall stud.
•
If the location is in drywall, first install a drywall anchor, then thread the screw into the
anchor.
Do not thread the mounting screws all the way in. The screw heads should protrude
approximately 0.25 inches (0.64 centimeters) from the mounting surface so that you can hang
the recorder on them.
8
Hang the recorder on the mounting screws. The recorder drops approximately 0.5 inches (1.27
centimeters) when hung on the mounting screws. The screws lock into the mounting hole
keyways, providing a positive locking mechanism.
9
Tighten the mounting screws.
Desk-Mounting
The SR model is shipped with rubber feet attached to the bottom of the unit, so that you can
safely mount it on a desk. The RR model is not intended for desk-mounting.
WARNING:
To ensure the unit meets the recommended operating temperature, the unit must be
desk-mounted in a location that ensures that it is unobstructed on all sides.
Mounting Screw
Recorder
