4. Updating via DPMS
Download the latest firmware from our website and update the firmware.
4.1. Network Connection
(1) System Requirements
•
Internet Connection by Broadband Circuit
•
Modem
•
Router
•
Ethernet cable (CAT-5 or greater is recommended)
(2) Setting
4.2. Check and update the firmware
Check if there is a firmware update available. It is also possible to check approximately how long the update will take.
(1) Turn on the power pressing "
X
" button.
(2) Press "
INPUT
" and "
Cursor
0
/
1
" buttons select to "
Setup
". Press "
ENTER
" button.
• Press "
Cursor
d
/
f
" buttons select to General For "
General
". Press "
ENTER
" button.
• Press "
Cursor
d
/
f
" buttons select to "
Firmware
". Press "
ENTER
" button.
• Press "
Cursor
d
/
f
" buttons select to "
Update
". Press "
ENTER
" button.
• Press "
Cursor
d
/
f
" buttons select to "
Check for Update
".
(3) Press the "
ENTER
" button.
• The latest version of the firmware uploaded to the web is displayed.
• If the latest firmware version is on the web, proceed to (4).
• If the latest firmware is already installed, press the "
INPUT
" button to close the Update menu.
(4) Press "
ENTER
" button. Select "
YES
", then press "
ENTER
" button.
(5) Firmware Update will be started.
---Cautions on Firmware Update---
•
For the update procedure, a proper broadband Internet connection environment and settings are required.
•
Do not turn off the power until updating is completed.
• It takes around 1 hour to complete the update.
Once an update is started, normal operations cannot be performed until it is completed.
The GUI menu settings and image adjustment settings of this unit may be initialized.
Note down the settings before updating, and set them again after updating.
Modem
Internet
Computer
ComputerLAN port / Ethernet connector
Ethernet connector of this Unit
Router
To WAN port
To LAN port
To LAN port
34
