PC2300 Operations Manual
15
PC2300 Operations Manual
___ 15
TOUCH SCREEN CALIBRATION
The PC2300 is shipped with a factory touchscreen calibration and should work out of the box. A
calibration tool is preloaded in the event that there is a problem with the factory calibration or the
touchscreen needs recalibration. If the calibration of the touchscreen is inaccurate to the point where
the touchscreen is not usable, a USB mouse can be used to access the calibration tool as described
below.
Use the following steps to calibrate the touchscreen:
1. Launch the eGalaxTouch utility by clicking on the desktop icon or through the start
menu:
All programs > eGalaxTouch > Configure Utility
2. Select the
tools
tab and press the
4 Points Calibration
button.
3. Follow the instructions in the calibration window to complete the touchscreen
calibration.
PCI CARD AND HDD / SSD INSTALLATION
This section describes how to remove the PC sub-assembly of the Panel PC from the display
assembly in order to access the hard drive and PCI express slot. The PC2300 will ship with a hard
drive installed and may be ordered with a PCI or PCIe riser card pre-installed so this section is not
required for a standard installation. However, these steps are necessary to replace a Hard Drive,
install a secondary Hard Drive, or to install a PCI or PCIe riser card.
REMOVE THE PC SUB-ASSEMBLY
1. Remove the four screws that secure the PC sub-assembly to the display assembly.
