F5 3D Imaging System User Manual
51
Polygon Mesh: Creates a mesh by creating surfaces with polygon
technique.
3
Click the Start button to start surfacing the file. A message is displayed at the
bottom of the window when surfacing is completed. The string _PC is
appended to the end of the file name.
NOTE
The STL file will be created at the location folder and can be found as
explained in page 42.
4
Click the Close button.
Defining KaplaVision Configuration Settings
The following describes how to configure KaplaVision decoding. This window is
automatically displayed when KaplaVision is launched the first time.
If this is the first time you are using KaplaVision or the first time you are using a
specific F5-B scanner, then you must check that the correct path is specified to the
decoding configuration file and the calibration files. These files will be provided to
you.
KaplaVision is provided with a configuration file in ZIP format that contains an RIG
file suited to your specific F5-B device. Typically, there is no need to modify the
fields pointing to these files.
NOTE
a new calibration RIG file can be created. These procedures are described in
Appendix C, Calibrating the F5-B scanner on page 117.
►
To configure KaplaVision:
1
Click the Configuration button at the top center of the KaplaVision window.
The following window displays:
