F5 3D Imaging System User Manual
123
Step 2: Wall (EPI) Calibration
►
To perform wall calibration:
1
Remove the Diffuser.
2
Using a plain white wall, stand at a distance of no less than 4 meters (157.5’),
parallel to the wall.
3
Hold the F5-B Scanner horizontal to the floor.
4
Start walking slowly toward the wall. Walk very slowly until the screen starts
to become shaded,
5
After the screen starts to shade, walk back at the same pace until within 2
meters (74.5’) of the wall.
6
Press the Stop button.
Step 3: RIG Calibration
RIG calibration is similar to camera calibration, with minor differences.
►
To perform rig calibration:
1
Without using the Diffuser, stand at an angle to the board, as shown below:
Figure 118: Standing at an Angle to the Board
