Operator’s Manual
Self-Propelled Scissor Lift
Version 1
37
3. Attach the lifting straps or chains to the designated lifting points of the machine.
4. Attach the other end of the lifting straps or chains to the lifting equipment (crane).
5. Adjust the lifting straps or chains to prevent damage to the machine and to keep the machine level
while lifting.
6. Lift the machine using the crane.
10
Transport Instructions
Observe and Obey:
•
Mantall provides this securement information as a recommendation. Drivers are solely
responsible for making sure machines are properly secured and the correct transport
vehicle is selected pursuant to localized regulations and their company policy.
•
Only qualified aerial lift operators should move the machine on or off the transport
vehicle.
•
The transport vehicle must be parked on a level surface.
•
The transport vehicle must be secured to prevent rolling while the machine is being
loaded.
•
Be sure the vehicle capacity, loading surfaces and chains or straps are sufficient to
withstand the machine weight. See the serial plate for the machine weight.
•
If the slope of the transport vehicle bed exceeds the uphill or downhill maximum slope
rating, the machine must be loaded and unloaded using a winch as described.
See the Specifications section for the slope ratings.
10.1 Towing the Machine (Only for Hydraulically Driven Machines)
1. Chock the wheels to prevent the machine from rolling when releasing the brakes.
2. Make sure the winch line is properly secured to the drive chassis tie points and the path is clear of
all obstructions.
3. Push in the brake release knob at the back of the chassis to open the brake valve of the hydraulic
drive motors.
4. Pump the brake release pump knob at the back of the chassis to release the brake of the
hydraulic drive motors.
5. Free the wheels and tow the machine to the desired position.
6. When the machine is at the desired position, chock the wheels to prevent the machine from
rolling.
7. Press and hold the function enable switch on the control handle of the platform controller. Move
the control handle off center to reset the brakes of the hydraulic drive motors.
Note
: Towing the Mantall machine is not recommended. If the machine must be towed, do not
exceed 3,2 km/h.
