Maintenance
Section 4
4-6
WATER PUMP
POWER CORD
OUTLET
WATER PUMP
1.
Disconnect the water pump power cord.
2.
Disconnect the water hose from the pump outlet.
3.
Loosen the screws that hold the water pump in
place.
4.
Lift the water pump and bracket assembly up and
off the screws.
Removing the Water Pump
WATER TROUGH
Remove the screws holding the water trough to the
walls of the cabinet. Refer to page 4-7.
WATER DISTRIBUTION TRAY
Remove the screws holding the water distribution
tray to the evaporator assembly. Refer to page 4-7.
WATER INLET VALVE
WARNING
Before removing any parts, unplug or disconnect
the electric power to the ice machine at the electric
service switch box, and turn off the water supply to
the ice machine.
1.
Turn off the water supply to the ice machine.
2.
Remove two Phillips head screws to remove the
lower panel on the front of the ice machine.
3.
Disconnect the inlet water tube from the valve.
4.
Disconnect the ice machine water line from the
valve.
5.
Disconnect all electrical wires from the valve.
Important
Write down where all electrical wires are attached
prior to disconnection to insure proper reassembly.
6.
Remove the screws holding the valve retainer
bracket to remove the valve from the ice machine.
7.
Disassemble the valve for cleaning.
8.
After cleaning, reassemble by referring to the
drawing below.
Water Inlet Valve
sv1684b
sv1715
SCREWS
COIL/RETAINER
BRACKET
ARMATURE
DIAPHRAGM
ARMATURE
GUIDE
COIL
SPRING
VALVE BODY
NUT
WATER LINE
BRASS
FITTING
SCREEN
FLOW
WASHER
O-RINGS/
SPACERS
O-RINGS/
SPACERS
