![Manitowoc National Crane NBT40 Series Service Manual Download Page 51](http://html.mh-extra.com/html/manitowoc/national-crane-nbt40-series/national-crane-nbt40-series_service-manual_701276051.webp)
2
NBT40 SERVICE MANUAL
HYDRAULIC SYSTEM
National Crane
Published 8-01-2017 Control # 287-11
2-15
Hydraulic Reservoir and Filter
The reservoir, (Figure 2-10) is attached to the front of the
truck bed and has a capacity of 100 U.S. gallons (378.5liters)
to the full mark. The all-steel reservoir has an internally
mounted full flow filter and integral baffles that help cool the
hydraulic oil and prevent foaming.
Hydraulic oil flows through the suction line at the bottom of
the reservoir to the hydraulic pump. Most of the return flow
goes through the filter at the top of the reservoir. The return
lines that go directly into the reservoir (instead of through the
filter) is from the swivel port 1, pump load sense, and
outrigger return lines.
A magnetized drain plug in the bottom of the reservoir
collects metal particles from the hydraulic oil if it becomes
contaminated.
A sight gauge is located on the side of the reservoir to
indicate hydraulic oil level.
A filler cap on the top of the reservoir is for filling the
reservoir. The filler cap includes a strainer for catching
contaminants and gaskets to prevent leaking. A breather cap
(vent) which is part of the filler cap allows air to enter or leave
the reservoir. The breather must be kept clean to prevent
damage to the reservoir.
A large access cover on the top of the reservoir provides
access for cleaning. The cover is secured to the top of the
reservoir with screws and has a gasket to prevent leaking.
The access hole can also be used to fill the reservoir after it
has been completely drained.
The hydraulic oil filter (Figure 2-10) is located in the reservoir
and bolts to the top of the reservoir. The filter housing
contains a replaceable filter element.
A filter element gauge on the filter head indicates how
restricted (clogged) the filter element is. When back pressure
caused by a dirty filter element exceeds 15 psi (103 kPa), the
filter head’s bypass feature allows the hydraulic oil to bypass
the filter and flow into the reservoir.
2
1
3
FIGURE 2-9
4
Reference Only
Summary of Contents for National Crane NBT40 Series
