PREVENTATIVE MAINTENANCE
CD5515-2/YB5515-2 SERVICE MANUAL
5-8
Published 1-20-2017, Control# 483-02
Lubrication Points
Apply grease to the following fittings after the first 20 hours of
operation, thereafter every 50 hours of operation or weekly,
whichever occurs first. Use a Lithium Base, E.P. No. 2
bearing grease or equivalent. Apply enough grease to
remove the old grease.
NOTE:
*Drive shaft u-joints do not require routine
lubrication. Lubricate only after major overhaul.
Booms and Main Frame
Location
QTY
Mast Bearing (see Figure 5-1)
2
Boom Pivot (see Figure 5-2)
2
Boom Head Sheaves and Pivot (see Figure 5-3)
2
Lift Cylinder Pivots (see Figure 5-5)
2
Drive Train
Location
QTY
Steering Knuckles- front axle (see Figure 5-6)
4
Steering Knuckles- rear axle (see Figure 5-7)
4
Steering Link- front axle (see Figure 5-8)
2
Steering Link- rear axle (see Figure 5-9)
2
Steering Cylinder Pivot Ends- front axle (see Figure 5-10)
2
Steering Cylinder Pivot Ends- rear axle (see Figure 5-11)
2
Drive Shaft- front axle (see Figure 5-12)*
2
Drive Shaft- rear axle (see Figure 5-13)*
2
Rear Axle Pivot (see Figure 5-14)
2
Optional Equipment and Accessories
Location
QTY
2
Jib Boom Head Sheave (see Figure 5-16)
1
Jib Boom Deflector Sheave (see Figure 5-17)
1
Reference Only
