Manitowoc GROVE GMK5150L, Operating Manual

Page: 900 / 1040

Rigging work
12.11 Other rigging work
12 - 152 3 302 709 en Operating manual
GMK5150L
1
2
.0
1.
201
8
12.11.4
Cameras for crane operation
Camera on
main boom For crane operation you have to install the camera and switch it on.
For on-road driving, you have to switch the camera off again and remove it.
The transmitter ( 1 ) and the associated
receiver ( 2 ) are matched to each other and
are identified by the same number on the
model plates.
Neither the transmitter nor the receiver should
be removed or installed; they remain together
on the truck crane at all times.
In the event of a defect, both transmitter and
receiver must always be replaced, even if only
one part is defective. When spare parts are
ordered both transmitter and receiver are
always delivered together.
•
Switch off the ignition in the crane cab.
G
Risk of accidents if an incorrect transmitter or receiver is used!
In the event of a defect, do not under any circumstances use a transmitter
or receiver from another truck crane.
This is to avoid the wrong image appearing on the monitor of your crane or
the monitor of a neighbouring crane.