Manitowoc GROVE GMK5150L, Operating Manual

Page: 284 / 1040

Driving modes and rigging for on-road driving
6.1 Driving modes
6 - 2 3 302 709 en Operating manual
GMK5150L
1
2
.0
1.
201
8
6.1.1
How to use the tables
H
This section only shows some standard driving modes. For further
information on additional or individual driving modes, please contact
Manitowoc Crane Care
.
The tables consist of two parts:
– The driving mode of your truck crane is specified in the top part, next to
Equipment . Find out which driving mode applies to your truck crane.
– The required rigging mode for this driving mode and the accessories
you are allowed to transport are specified in the lower section, next to
Rigging mode .
Example of how to use the table:
Assume your truck crane is equipped with 385/95 tyres, 6 x 10 x 10 drive.
Equipped with a retarder and towbar for a trailer. In addition, the auxiliary hoist
or the 1.0 t counterweight is mounted.
In this case the driving mode in the upper part, next to equipment, is
1 .
According to the specifications in the lower part, in addition to rigging mode,
– the 1-sheave hook block must be attached to the front bumper.
– the hose drum is installed on the main boom,
– the 1,8 m + 16 m swing-away lattice is folded to the side,
– a 2.3 t counterweight lies on the counterweight platform
– a 4.6 t counterweight may be installed on the turntable
Additional parts must be transported on a separate vehicle.
H
If you remove indicated parts from the truck crane in driving mode, then the
total weight decreases but might be distributed in such a way that the front
or rear axle loads are over 12 t.