Manitowoc Grove GMK 4100L-1, Operating Manual

Page: 620 / 1016

Crane operation
11.4 Operation of the rated capacity limiter
11 - 32 3 302 690 en Operating manual
GMK4100L-1
2
3
.1
1.
201
7
11.4.2
Enter rigging mode
Notes on Input You can enter the rigging mode for various different purposes.
– Entry for crane operation
You enter the current rigging mode, select a telescope status according to
the lifting capacity table and confirm the rigging mode to enable the crane
functions.
– Entry for operations planning
You enter a possible rigging mode to check the lifting capacities, slewing
ranges and telescopings that are enabled with this rigging mode.
H
You can only change the rigging mode when all crane movements have
stopped – control lever in the initial position.
•
If necessary, open the Enter rigging mode/telescope status menu ( 1 ) on the
CCS
display.
The
RCL
display shows the
Lifting capacity table
menu.
The CCS shows the Enter rigging mode/telescope
status
for the last rigging mode entered.
The rigging mode is entered at the
CCS
display – after each change, the
RCL
display
shows the corresponding lifting capacity
table (
2 ) and the enabled slewing range ( 1 ).
The input options and the displays are based
on the confirmed slewing range type.
First enter the slewing range type;
à
p. 11 - 33.