Manitowoc Grove GMK 4100L-1, Operating Manual

Page: 587 / 1016

Starting/switching off the engine – for crane operation
10.4 Switch off the engine
Operating manual 3 302 690 en 10 - 11
GMK4100L-1
2
3
.1
1.
201
7
10.4 Switch off the engine
10.4.1 At the ignition lock and with hand-held control
If the hand-held control is not connected:
•
Turn the ignition key to position 0 – the engine will stop.
The crane control is switched off.
If the hand-held control is connected:
•
Press the ( 1 ) button once – the engine will switch off.
In this case it is not possible to switch the engine off via the ignition lock.
After switching off Refer to the instructions in the respective sections for each type of stopping
work;
à
In case of short work breaks , p. 11 - 149,
à
In case of work breaks of more than 8 hours
, p. 11 - 150.
10.4.2 With the idling button
•
Push the button ( 1 ) down and hold it there.
– After about 3 seconds the idling speed will be at the standard value.
– After a further about 3 seconds, the engine will switch off – the crane
control remains switched on.
The engine cannot be restarted until about 7 seconds have elapsed.
G
Risk of accident by suspended loads
Never switch off the engine whilst a load is suspended. You must have the
control levers at hand in order to intervene at any time.
Always set down the load before you leave the crane cab.