Manitou Mezzer Expert, Service Manual, Page: 22 / 43

22
MEZZER SERVICE MANUAL
1
2
4
Install the black “HI-SPEED”
adjustment knob onto adjuster
hex. With a 11mm socket, thread
on the lock nut and torque to 4-6
in-lb [0.5-0.7 Nm] Note: Be sure to
hold the knob still while installing
the nut. The damper adjuster may
be damaged if the knob is over
torqued.
Clean fork and use a shock pump
to set to desired pressure. Lightly
pull the casing away from the CSA
as you add air. See Mezzer Pro
set-up sheet for recommended air
pressures.
Clean the adjuster knobs with
isopropyl and replace v-seal into
top-cap counter-bore.
Pro Compression Knob Installation
3
Lubricate o-ring seal on red “LO-
SPEED” adjustment knob with
Slickoleum™ Grease an install onto
adjuster hex. With a 2mm hex,
thread on the screw and torque to
4-6 in-lb [0.5-0.7 Nm] Note: Be
sure to hold the knob still while
installing the screw. The damper
adjuster may be damaged if the
knob is over torqued.