Manitou 100 SC-2, Operator'S Manual

Page: 96 / 104

3-24
D6 - Hydraulic oil
DRAIN - REPLACE
- Set the platform on a horizontal surface in transport position, with the engine switched off.
- Raise the work platform approximately 3m.
- Turn the maintenance and then lower the scissors assembly by pressing on the arm.
- Close the hydraulic circuit shut off valves if the platform is equipped with these.
Use a very clean container and funnel and clean the top of the oil can before
filling.
Dispose of the drained oil in an environmentally friendly manner.
The engine should not start if the automatic shut off valves on the hydraulic
reservoir are in the closed position: there is a risk of damage to the components.
If the reservoir valves are shut, remove the machine’s ignition key and stick a label on the platform to inform personnel of
its condition.
- Remove the drain cap from the hydraulic reservoir and drain the reservoir completely into an appropriate container.
A fine spray of hydraulic oil can penetrate and burn the skin. Loosen hydraulic connections very slowly to enable the
hydraulic pressure to dissipate gradually.
D6
Closed Open
647367
(01/03/2017)
100/120
SC-2
/ 140
SC