Manitou 100 SC-2, Operator'S Manual

Page: 93 / 104

3-21
- Locate the terminal strip behind the ground control console.
- Identify and disconnect the black wire from the maximum height switch bundle on terminal A10 on the strip.
- Identify and disconnect the white wire from the maximum height switch bundle on terminal B9 on the strip
- Connect a wire between connectors A10 and B9 on the strip.
- Turn the key switch on the base control console and ensure that the Emergency Stop knobs are not engaged.
- Perform a work platform lifting command and then release the control.
- The engine must stop. An alarm must sound and Code 99 “OVERLOAD PLATFORM FAULT” appears.
- If the engine does not stop, if the alarm does not sound, or if Code 99 does not appear, please refer to the Repairs Manual. Lower the
scissors assembly using the emergency pump on the base console and lower the work platform approximately 4.5m.
- Turn the key switch to position 0.
- Disconnect the wire between A10 and B9 on the terminal strip.
- Connect the black wire for the maximum height switch to terminal A10 on the strip.
- Connect the white wire for the maximum height switch to terminal B9 on the strip.
In the event of a malfunction prevent use of the platform. Contact your dealer.
C6- Backup pump
CHECK
- Please refer to “RESCUE PROCEDURE” in Section 2.
C7 - Axles
GREASE
- Clean and then grease the grease nipples (See the “LUBRICANTS” section) and remove any surplus.
C8 - Tightness of the reducer fixing screws on the chassis
CHECK
- Check the tightness of the reducer fixing screws on the chassis.
C9 - Machine stickers
CHECK
- Check that the safety stickers are in place (See: 1 – SAFETY STICKERS).
C10 - Front and rear wheel reducer oil
DRAIN - REPLACE
Set the platform on a horizontal surface with the engine off and the reducers’ oil still warm.
- Drain and replace the oil of each of the front and rear wheel reducers.
- Set the drainage plug 1 (Fig. C10) to position A.
- Place a receptacle under the drain plug and unscrew it.
- Leave the oil to drain out completely.
Dispose of the drained oil in an environmentally-friendly manner.
- Set the drain hole to position B, i.e. to level hole.
- Refill with oil (see the LUBRICANTS section) via the level hole 1 (Fig. C10).
- The level is correct when the oil is flush with the hole.
- Refit the drain plug 1 (Fig. C10) and tighten it.
- Perform the same operation for each of the wheel reducers.
C10
1
B
A
647367
(01/03/2017)
100/120
SC-2
/ 140
SC