Cayenne
™
Series
V.121806
4.5
Install Remote Sensor
Using Remote
Sensor
For M&R presses which do not include pre-wired plug sockets on the electrical enclosure, the flash
cure is operated and controlled through the use of a remote sensor assembly.
The remote sensor supplies the signal to the flash cure in this type of installation. Ensure the digital
controller is set for Proximity or
PRX
.
Step 1
Position the floor stand (1) and sensor (2) underneath the
index table pallet at the print station just before the print
station where the flash cure is located. Position the sensor
to read the lower pallet support arm just as it starts the
index cycle.
Step 2
Install the signal cable from the sensor floor stand to the
socket (1) marked
PLC/SENSOR SIGNAL
on the flash
cure.
Step 3
Press the
F4
key twice to select the mode of operation for
the flash cure, PLC mode or Proximity mode. The control
displays
MODE
on the upper line, and either
PRX
or
PLC
on the lower line indicating which mode is currently
selected. Press the arrow keys to change the mode.
Note: In
PLC
mode, the flash cure receives its start signal from
the PLC on the press. In
PRX
mode, the flash cure
receives its start signal from the floor stand mounted
proximity switch.
18
M&R Companies 1N 372 Main St. Glen Ellyn, IL 60137 USA
Tel: +630-858-6101 Fax: +630-858-6134
www.mrprint.com
