M&C GenTwo PMA1000V2.4, Instruction Manual

Page: 43 / 110

42
GenTwo® PMA1000 V2.4 | 1.00.00 www.mc-techgroup.com
The operational parameter Lim2 can be changed in the same way as Lim1, by clicking on
the corresponding Edit button. A scroll bar will open, where you can select numbers be-
fore and after the decimal point. The selected value needs to be displayed in the gray
frame in the middle of the operational parameter scroll bar. Please tap on the green check
mark to confirm your selection.
Fig. 43: Highlighted scroll bar to set operational parameter Lim2
1
Selected value for Lim2
2
Active edit button changes into a check mark
3
Indicators for exceeding the value of operational parameters Lim1 and Lim2
To define operational parameter values and change the calculation method behind the
values, please refer to chapter “ M4/S2 - Settings menu/ parameters”.
8.3.11 M4/S2 - Settings menu/ parameters
Qualified
personnel
Changing settings can only be done by qualified personnel.
In section M4/S2 you can define the parameters for the scroll bars you are using in section
M4/S1. The screen of section M4/S2 shows a scroll bar and a green “Restart” button.
1
2
3