Man iSea, Operating Instructions Manual, Page: 124 / 172

Parametrization start/stop
122
Read this manual carefully before starting any work!
This is particularly applicable to the chapter “General Safety Instructions”
and the respective safety instructions in the chapters.
14 Parametrization start/stop on 7" touch display
General information:
This function is available for the non-classified application with 5 or 7 inch touch display. (The dual display,
two engines on one display, is also excepted from this.)
As maximum equipment, up to six displays with start/stop function can be parametrized for each engine.
Here, the 5 and 7 inch displays are equivalent. That is, the number of desired displays with start/stop
function can be distributed as required to the two display variants.
14.1 Parametrization
Entry via the main menu
Then switch to the sub-menu
The page Start/Stop Settings opens:
Left “area”:
Serves for “System configuration” (functionality of
the displays from one engine in the network) – the
number of “start/stop stands configured in the
system” is displayed.
Right “area”:
Serves for configuration of this display – shows the
ID with which the start/stop stand is parametrized
in the display.