Man iSea, Operating Instructions Manual, Page: 10 / 172

Preface
8
Read this manual carefully before starting any work!
This is particularly applicable to the chapter “General Safety Instructions”
and the respective safety instructions in the chapters.
1.2 Copyright protection
All information, texts, drawings, figures and other content are protected by copyright law and subject to
industrial property rights.
Any improper use shall be liable to prosecution.
Corporate identity
MAN, their respective logos, as well as corporate and product identity used herein, are trademarks of MAN
and must not be used without permission.
1.3 Safety instructions
Most industrial accidents during the installation, operation, maintenance and repair of the products are
caused due to non-compliance with basic safety regulations and protective measures. An accident can
often be avoided by recognizing potentially hazardous situations before an accident occurs. An installation
technician must be alert to potential hazards. The technician must also have the necessary training, skills
and tools in order to perform these works properly. The information in this publication was based upon
current information at the time of publication. Check for the most current information before you start any
job. MAN dealers will have the most current information.
1.4 Liability for material defects
Claims for liability for material defects can be lodged against MAN within the framework of the conditions of
sale and supply as agreed and stipulated in writing, only if:
S
The instructions has been followed during engine installation.
S
The initial installation acceptance was conducted by MAN.
S
The defects found in the process have been remedied by the device manufacturer and clearance has
been granted by MAN.
S
The series installation corresponds to the initial installation approved by MAN.
S
Only service products approved by MAN are used.
S
The prescribed service intervals are complied with.
S
The maintenance and repair works are carried out by MAN service branches and MAN authorized
workshops.
S
No unauthorized intervention in the engine control (tuning) were carried out.
In case of special editions, if additional ordering options have been selected, or due to the latest
technological developments, the actual scope of supply may vary from the explanations and illustrations
described herein.
The obligations agreed upon in the supply contract and the general terms and conditions of MAN, and the
statutory regulations valid at the time of concluding the contract shall be applicable.