18
|
back rest drive is ready for use in every position after travelling
a short distance.
Upper leg section
Use the corresponding button on the hand controller to adjust
the upper leg section.
((Upper leg section operating button))
For safety reasons, this position should only be adjusted by
medical personnel.
The lower leg section can be put into a horizontal position by
nursing staff using a fine adjustment device. (stretched leg high
positioning)
Height adjustment
Use the corresponding button on the hand controller to adjust
the height.
(Height adjustment operating button)
Caution ! Please consider patient safety when
adjusting height! No other objects should be in
the area of the lifting mechanism.
D E S C R I P T I O N O F F U N C T I O N
Depending on the design and type of clinical bed, the bed can
be put into the following positions by adjusting the back rest,
the upper leg and the lower leg sections as well as the height
of the bed:
Back rest
Use the corresponding button on the hand controller to adjust
the back rest.
(Back rest button)
The back rest has a range of movement equivalent to a length
compensation to the head section of the bed of 120 mm.
This function (mattress compensation) allows the patient to sit
in a comfortable position without compressing or restricting the
stomach or upper body.
Mechanical release of the
Back rest (CPR)
When using mechanical release of the back rest, hold it firmly
in the position engaged and take some weight off it if possible.
Then pull the release mechanism until the back rest goes down
noticeably. Slowly allow the back rest to fall back into its final
position.
Engaging the release mechanism:
Press the appropriate button (S2) on the hand controller; the
Summary of Contents for Impulse 300 KL
Page 1: ...IMPULSE KL SERIES INSTRUCTIONS FOR USE CLINIC DESIGN...
Page 2: ...2...
Page 6: ...6 Room representation Impulse 300 KL Impulse 400 KL...
Page 29: ...29...
