Malaguti PHANTOM MAX 125, Owner'S Manual, Page: 147 / 252

45
EN
A
B
Fig. 35
A1
Fig. 35a
B
P
INTRODUCTION
In most cases, it is no longer possible to replace lamp bulbs
without previously disassembling some scooter components.
To do this, special know-how and appropriate tools are required.
Therefore, we recommend having bulbs replaced by an
Author-
ised Malaguti Service Centre.
6.1 HEADLIGHT
• The front headlight features two lights: the low beam (A - fig.
35) and the high beam (A1 - fig. 35). To select the low or high
beam, first turn the right-hand light switch to position and
then press the left-hand light button.
• Low beam headlight (Pos. A – Fig. 35)
Halogen lamp, 12V – 65W HB3
• High beam headlight (Pos. A1 – Fig. 35)
Halogen lamp, 12V – 55W H3
• Two parking lights (Pos. B – Fig. 35)
Lamp, 12V – 3W
• The parking light is switched on when the right-hand light switch
is in the central position . The parking light is located in the
section of the light, which is not used either for the low beam or
high beam.
Note: we advise you to check if the replaced bulb works properly
before refitting the headlight unit definitively.
ELECTRICAL EQUIPMENT
6
6.2 BEAM ADJUSTMENT
Have the beam of the headlight periodically checked by an
Authorised Malaguti Service Centre .
The height of the lights can be adjusted by means of the knob
under the lamp (P - fig. 35a); tighten the knob to raise the lamp
or loosen it to lower the lamp.