October 2015
4.5.4.
SAW BLADE (ADJUSTMENT FOR MAX CUTTING CAPACITY)
Figure 82
1. Pull Motor unit and lower it until it stops.
2. Turn M6x16 Hex socket head bolt (42) with Hex wrench 5 to move the outer periphery of blade to the grooves on Kerf
boards (171 or 172) when Motor unit is in the lowest position.
Note:
Saw blade must not touch Kerf boards (171 or 172) and Base complete (194).
4.5.5.
GUIDE FENCE
Figure 83
1. Temporarily tighten M6x25 Hex socket head bolt with WG (115) into Screw hole A.
2. While checking the angle of 1R208 to saw blade, adjust Guide fence (114) by moving its right end until the angle sets
at 90°.
Motor unit
(42)
Groove
A
B
C
Screw hole A
is smaller than
Screw hole
1R208
Saw blade
(115)
Operator’s position
Right end of Guide
fence (114)
(172) (171)
(194)
(114)
42 / 47