Cutter holder
Modified Hex wrench 5 (See previous page.)
1R308
[3] DISASSEMBLY/ASSEMBLY
[3] -2. Head case complete (cont.)
(3) Disassemble Head case complete as drawn in
Fig. 5
.
Assemble Head case complete in the reverse order of Disassembly. Refer to
Fig. 5
.
Be careful to the directions of Washer and Bearing washer. (
Fig. 6
)
Fig. 5
1. Lock Cutter holder with 1R308 inserted into its hole.
Hold Head case complete with vise.
Insert the modified end of Hex wrench 5 to the square
hole of Cutter shaft.
Cutter holder is removed from Head case complete by
turning Hex wrench 5 counterclockwise.
2. Put Head case complete on Turn table of
Arbor press. Press Cutter shaft with 1R286.
Cutter shaft section is separated from
Head case complete.
3. Disassemble Cutter shaft section as drawn below.
DISASSEMBLING
ASSEMBLING
Cutter holder
Cutter shaft
section
1R286
Cutter shaft
Cutter shaft
Bearing washer
Head case
complete
Head case
complete
Head case complete
Head case
Ball bearing 608ZZ
Ball bearing 608DDW
Collar
Washer
Spring washer M8
Bearing washer
Washer
Spring washer 8
Ball bearing 608ZZ
Ball bearing 608DDW
Cutter shaft
Collar
Cutter holder
Fig. 6
R
epair
P
5
/ 1
3
Face the projection of Washer and Bearing washer to the opposite direction of Cutter holder.
