5
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing abrasive belt
Fig.4
Pull the cam lever all the way out. Install the belt over
the rear pulley, and slip the belt over the front pulley,
with the belt pulled out to the front arm. Return the cam
lever to the original position.
Adjusting belt tracking
Fig.5
Switch on the tool and make sure that the belt is aligned
properly.
Use the adjusting dial to center the belt tracking. Turn
the adjusting dial clockwise to incline the arm to the
right, or counterclockwise to incline it to the left.
Connecting to Makita vacuum cleaner
Fig.6
CAUTION:
•
Always close the nozzle cap when the vacuum
cleaner is not connected to the nozzle. Never
insert your finger into the nozzle.
Cleaner sanding operations can be performed by
connecting the belt sander to Makita vacuum cleaner.
Open the nozzle cap, and install the dust nozzle.
Connect the hose of a vacuum cleaner to the dust
nozzle.
When connecting to Makita vacuum cleaner, an optional
hose 28 mm in inner diameter is necessary.
Fig.7
OPERATION
Hold the tool firmly with both hands. Turn the tool on and
wait until it attains full speed. Gently apply the tool to the
workpiece surface and move the tool forward and back.
Press the belt only lightly on the workpiece. Excessive
pressure may damage the belt and shorten tool life.
Always use "A" range of the belt to sand the workpiece.
“A” range
1
001223
Fig.8
Fig.9
CAUTION:
•
Secure the workpiece with clamps, etc. if there is any
possibility of it moving during the work operations.
•
The tool should not already be in contact with the
workpiece surface when you turn the tool on or off.
Otherwise a poor sanding finish, damage to the
belt or loss of control of the tool may result.
•
When working with the tool, be very careful to
avoid any contact of the tool and belt with any part
of your body or anyone or anything near you.
MAINTENANCE
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before attempting to perform inspection
or maintenance.
•
Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.
Replacing carbon brushes
Fig.10
Remove and check the carbon brushes regularly.
Replace them when they are worn down to the limit
mark. Keep the carbon brushes clean and free to slip in
the holders. Both carbon brushes should be replaced at
the same time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
Fig.11
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
OPTIONAL ACCESSORIES
CAUTION:
•
These accessories or attachments are
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
•
Abrasive belts
•
Hose 28
•
Arm (6, 9, 13 mm)
•
Dust nozzle assembly
NOTE:
•
Some items in the list may be included in the tool
package as standard accessories. They may differ
from country to country.
1. Flat shoe