MAKINEX MS-150
Operator’s Manual Rev0322
Page 10 of 15
6. Using a controlled motion (use the
MS-150
Side Handle and Rear Handle) pour mixed
Levelling Compound where required.
STEP 4
– MAINTAINING THE MS-150
CAUTION
ALWAYS
use two people when loading and unloading the
MS-150
.
1. It is very important to clean the equipment after use. Use water or a high-pressure hose to
clean all Levelling Compound from the
MS-150
Frame, Vac Lid Module, Wheels, Bucket
and Helix Paddle after use. The water nozzle in the vac lid module can be removed and
used for cleaning.
2. Extra attention should be focused on cleaning the Wheels.
3. Wheels should be oiled / greased regularly.
4. The ventilation slots on the Makinex Electric Mixer motor casing should be cleaned out
periodically
5. After 100 hours of operation check the carbon brushes in the Makinex Electric Mixer.
When the carbon brushes are worn see the diagram below to replace the carbon brush.
One pair of replacement carbon brushes are included. Remove the brush cap with a flat
blade screwdriver and remove the worn carbon brush. Place new carbon brush into the
brush holder inside. Replace and tighten brush caps with flat blade screwdriver.
6. After 200 hours of operation renew the grease filling the gearbox
NOTE:
With two
MS-150
Portable Mixing Stations, another mix could be completed
using the same Mixer while one is being poured.
