Compatibility Checklist
Getting Ready
This safety device is meant to be installed and used in conjunction with a power tool. Prior to
completing the compatibility checklist, collect the following items:
●
The MAKESafe Power Tool Brake.
●
The power tool you intend to use with this brake with.
●
The instruction manual and specifications sheet for your power tool.
As the owner of this safety device and your pre-existing power tool, it is your responsibility to
complete this compatibility checklist before installing this safety device. If you cannot complete the
checklist, do not install the device.
Checklist
For More Information
❏
Confirm that the voltage, number of phases, and
frequency of your
power tool
match the voltage,
number of phases, and frequency indicated on your
brake.
This is typically marked on the motor
itself and on the top of the brake.
❏
Confirm the motor horsepower on the
power tool
is
rated at or below the horsepower rating of your
brake
.
This is typically marked on the motor
itself.
❏
Confirm the
power tool
has the same plug and
receptacle type as your
brake
.
See section below titled
Identifying
Receptacles.
If you plan to hardwire
the device, you can ignore this
section.
❏
Confirm the
power tool
uses an AC induction motor
for its motive force.
See section below titled
Identifying
Motor Type
❏
Confirm the
business end
of the
power tool
is not
mounted on a reverse threaded spindle or confirm
that you will operate the brake within the limits
described in the section
Understanding
Reverse-Threaded Spindles.
See section titled
Understanding
Reverse-Threaded Spindles.
❏
Confirm the
power tool
contains only a simple on/off
switch (for plug-and-play installation) or contact
MAKESafe Tools for guidance on how to install the
brake
on your particular machine.
See section titled
Recognizing
Existing Controls
❏
Confirm the
power tool
does not contain an integral
circuit breaker.
Review your tool manual and inspect
your tool to ensure there are no
integral circuit breakers.
MAKESafe Tools, Inc. | Copyright 2021 | Last Updated 12/29/21
Page 5
