MakerPi K300, User Manual, Page: 21 / 43

21

Next will continue to install the slicing
software. After the green progress bar is
complete, click
"Next"
.

Finally, click Finish to complete the
slicing installation.

After installation, the software will
automatically open and menu (in
the right image) will appear.
5.2
Introduction to the application of slicing software
5.2.1 Fast print
（
Not recommended for use
）
Click ”Experts configuration” - switch
to “Fast print mode”

Fast print: No need for users to set
parameters themselves, all parameters
will be set to the corresponding default
value as required.
The options in the diagram include
printing patterns, materials, and whether it is
supported.