CALIBRATION PG. 4
LAST UPDATE 06.07.19
STEP 9: SCREEN 5 MEASURING DISTANCE BETWEEN MOTORS
• If value is still at 1000mm change to 10 MM
• Click RETRACT until most, but not all slack is gone
CAUTION: during the next step, the chain
may come off the right sprocket. It can be
under a lot of tension and if it comes off,
make sure you’re not within range
A carefully placed small piece of duct tape
may provide some stability. Just be sure
the tape doesn’t interfere with movement
of the sprocket.
STEP 10: SCREEN 5 MEASURING DISTANCE BETWEEN MOTORS
•
Pay attention to motors and frame during this time, if motors move or frame flexes, make
adjustments to your frame so this doesn’t happen
• Click PULL CHAIN TIGHT AND MEASURE. During this step, slack will be taken up and software
will determine, distance between motors based upon how much chain is fed out.
• Chain will slacken up when operation is done
• Remove chain from frame, set aside until later