Electrocution hazard!
The Make Noise LxD is an electronic music module requiring 30 mA of +12VDC and 30 mA of -12VDC
regulated voltages and a properly formatted distribution receptacle to operate. It must be properly
installed into a Eurorack format modular synthesizer system case.
Go to
http://www.makenoisemusic.com/systems.shtml
for examples of Eurorack Systems and Cases.
To install, find 4HP in your Eurorack synthesizer case, confirm proper installation of included eurorack bus
board connector cable on backside of module (see picture below), plug the bus board connector cable into
the Eurorack style bus board, minding the polarity so that the RED stripe on the cable is oriented to the
NEGATIVE 12 Volt line on both the module and the bus board. On the Make Noise 6U or 3U Busboard,
the negative 12 Volt line is indicated by the white stripe.
supply.
Always turn the Eurorack case off and unplug the power cord before plugging or un-plugging any Eurorack
bus board connection cable cable.
Do not touch any electrical terminals when attaching any Eurorack bus board cable.
-12V
Summary of Contents for LxD
Page 1: ...v 1 0...