4
Please refer to your case manufacturers’ specifications for location of the negative
supply.
Installation
Electrocution hazard!
Always turns the Eurorack case off and unplug the power cord before plugging or un-plugging any Eurorack bus board
connection cable. Do not touch any electrical terminals when attaching any Eurorack bus board cable.
The Make Noise DynaMix is an electronic music module requiring 55 mA of +12VDC and 45 mA of -12VDC regulated voltages and
a properly formatted distribution receptacle to operate. It must be properly installed into a Eurorack format modular synthesizer
system case.
Go to
http://www.makenoisemusic.com/
for examples of Eurorack Systems and Cases.
To install, find 10HP in your Eurorack synthesizer case, confirm proper installation of included Eurorack bus board connector cable
on backside of module (see picture below), plug the bus board connector cable into the Eurorack style bus board, minding the
polarity so that the RED stripe on the cable is oriented to the NEGATIVE 12 Volt line on both the module and the bus board. On
the Make Noise 6U or 3U Busboard, the negative 12 Volt line is indicated by the white stripe.
-12V
Summary of Contents for DynaMix
Page 1: ...v 1 0...