1. If you wish to measure temperature in
°
F, set the function switch to
the °F range. If you wish to measure temperature in °C, set the
function switch to the °C range.
2. Insert the type-K thermocouple probe black test lead banana plug
into the negative COM jack and the red test lead banana plug into the
positive Temp jack.
3. Touch the Temperature Probe head to the part whose temperature
you wish to measure. Keep the probe touching the part under test
until the reading stabilizes (about 30 seconds).
4. Read the temperature in the display. The digital reading will indicate
the proper decimal point and value.
6.15. TEMPERATURE MEASUREMENTS
WARNING:
To avoid electric shock, disconnect both test probes
from any source of voltage before making a temperature
measurement.
1. When the batteries become drained or drop below the operating
voltage, “BAT” will appear in the right-hand side of the LCD display.
The battery should be replaced.
2. Follow instructions for installing battery. See the Battery Installation
section of this manual.
3. Dispose of the old battery properly.
6.16. REPLACING THE BATTERY
6.17. BATTERY INSTALLATION
WARNING:
: To avoid electric shock, disconnect the test leads from
any source of voltage before removing the battery door.
1. Disconnect the test leads from the meter.
2. Open the battery cover by loosening the screw using a phillips head
screwdriver.
10
14
WARNING:
To avoid electric shock, be sure the thermocouple has
been removed before changing to another measurement function.
WARNING:
To avoid electric shock, disconnect the test leads from
any source of voltage before removing the battery door.
WARNING:
To avoid electric shock, do not operate your meter until
the battery cover is in place and fastened securely.
Summary of Contents for MT24
Page 1: ...INSTRUCTION MANUAL 1000V AC DC MULTIMETER MT24...
Page 2: ...2...