MIGE2210 Series Gigabit Din-rail Switch
- 11 -
4. Hardware Installation
4.1. Din-rail Installation
For most industrial applications, the 35mm standard DIN rail mounting is
very convenient. When you remove the device from the box, the DIN rail
connector is fixed to the rear panel of the MIGE2210 series switch. If you need
to mount the card on the DIN rail, you should check the DIN rail installation
before installation. It mainly includes the following two items:
Whether the DIN rail is fixed or not, and whether the DIN rail has enough
space for installing the switch.
Is there a power supply on the DIN rail suitable for the operation of this
switch?
After selecting the installation location of the switch, install the switch to
the DIN rail as follows:
Insert the upper part of the DIN rail into the card slot of the circlip on the
upper part of the DIN rail connector. Rotate the device slightly on the upper
panel of the switch and turn the device as shown in A in Figure 4-1.
Insert the DIN rail into the DIN rail connector as shown by B in Figure 4-1.
Make sure that the MIGE2210 series switch devices are securely mounted to
the DIN rail.
Figure 4-1 DIN rail installation of the MIGE2210 series switches
4.2. Cable Connection
After the MIGE2210 series switches are properly installed, the cable can
be installed and connected, including the cable connections of the following
interfaces.
Business interface:
The terminal devices provided by this series of products are Gigabit, 100M
Ethernet RJ45 interfaces and Gigabit and 100M Fx ports, so they can be
connected to terminal devices or network devices using direct-connected
network cables and fiber-optic cables.
