MIEN2204 Series Unmanaged Industrial Ethernet Switch
- 8 -
Grounding and wiring can effectively suppress the noise impact caused by
electromagnetic interference. The ground connection should be made before
connecting the equipment, from the ground screw to the ground surface.
3.2. Installation
3.2.1. Din-rail Installation
For most industrial applications, it is very convenient to install with 35mm
standard DIN rail. When you remove the device from the packing box, the DIN
rail connection seat should be fixed on the rear panel of the MIEN2204 series
switch. If MIEN2204 series switches need to be mounted on DIN rail, you
should check the installation of DIN rail before installation. It includes the
following two contents:
Whether the DIN rail is fixed and strong, whether other equipment is
installed on the DIN rail, and whether there is enough space for installing the
switch.
Weather Is there any power supply suitable for the work of this switch on
the DIN rail.
After selecting the installation location of the switch, install the switch on
the DIN rail as follows:
Insert the upper part of the DIN rail into the snap groove of the upper part
of the DIN rail connection seat with a snap spring. Push down slightly on the
top panel of the switch and rotate the device as shown in below
Install MIEN2204 series switches to Dil-rail
cable connection
After the MIEN2204 series switches are correctly installed, the cables can
be installed and connected, mainly including the cable connections of the
following interfaces.
RJ45 interface
