Version
:
V1.0
(
2020.02
)
Copyright © 2020 Mainlink All Rights Reserved
16
M52 with Mission Planner
Follow the steps to use M52 with Mission Planner
:
1. Connect the UART1 of M52 air unit to flight controller, such as Pixhawk. Connect the gimbal to
one ethernet of M52.
2. Making sure all the air and ground cable connection is finished. Power on the system.
3. Install Mission Planner to your computer.
4. Set the IP address of the computer.
Open “Network and Internet”setting.
Select “Internet Protocol version 4 (TCP / IPv4) properties”.
Change IP address to “192.168.1.xxx”
(
xxx is in 0
~
255 , you cann
’t use IP 192.168.1.200
and 192.168.1.236, because these IP were set in M52
)
.
Attention:The IP “192.168.1.XXX”is just an example. You need to set up your
PC the same IP section as your gimbal.