MAIMAN ELECTRONICS MBL1500B, User Manual

Page: 9 / 24

Maiman Electronics MBL1500B
8
8. To turn on, press the Laser and TEC buttons. The buttons will light up in green. Status bars
Current LD and TEC will light up in green. If you turn on LD without TEC, the TEC button will flash. If you
failed to turn on the Laser and TEC, check the status bars Error and Interlock . They should not be
highlighted in red (paragraph 15.1 The Main screen);
9. To turn off, press the Laser and TEC buttons again. The buttons will light up in red. Press the
Standby button. Turn off the power by button on the back panel.
Screen description 15.
Before switching on the TEC and Laser, set the parameters and settings for the MBL1500 in
accordance with the specification of the laser diode. The next section describes setting parameters
and settings in detail.
15.1. The Main screen
Fig. 7 – The Main screen
MBL1500 has a duplicate control using buttons and encoder and/or touchscreen. Button control
will be described at first. Touchscreen control will be described later, as an option.
Table 3. The Main screen submenus description
Submenu Description
LD Setpoint Allows to change LD current, frequency and duration (Function button 1)
TEC Setpoint Allows to change temperature (Function button 2)
Settings Allows to set limits, calibrate LD and TEC current, adjust screen brightness, get general
information, disable/enable touchscreen, etc. (
Function button 3)
Memory Allows to save the set parameters ( Function button 4 )
Control with buttons and encoder
To go to the submenu, press the Function button that corresponds to the required submenu.
Control with touchscreen
To go to the submenu, tap the button icon on the screen that corresponds to the required
submenu.