Maico ALD 10, Mounting And Operating Instructions, Page: 12 / 12

12
 Clean air filter in lukewarm soap suds, then
leave to dry.
 Vacuum wall sleeve, if necessary.
 Insert air filter in internal cover. Clip outer
filter holder onto 4 corner points.
 Press entire cover unit onto connection
coupling until it snaps into place.
Remember the slide slot.
ALD 10 T
 Unscrew valve disk.

Take out air filter and clean in lukewarm
soap suds, then leave to dry.

Insert air filter and screw on valve disk.
Refer to section 5.1 for basic setting.
ALD 12 S, ALD 12 SVA
 Take off internal cover.
 Take out air filter and clean in lukewarm
soap suds, then leave to dry.
 Insert air filter.
 Press internal cover onto connection
coupling until it snaps into place. Ensure
that the unit is open to the top once
installed.
7.
Disposal
Do not dispose of in domestic
waste.
The unit contains in part material that
can be recycled and in part
substances that should not end up as
domestic waste.
 After its working life has elapsed, dispose
of the unit according to valid regulations
where you are.
8.
Characteristic curves
ALD 10
Example
Loss of pressure: 8 Pa
Volumetric flow required: 20 m³/h
Slide position 6
ALD 10 T
ALD 12 S, ALD 12 SVA
Maico Elektroapparate-Fabrik GmbH • Steinbeisstr. 20 • 78056 Villingen-Schwenningen •
Germany • S49 7720 694 447 • technik@maico.de
i
GB
Kennlinie
Pa
-
P
tPa
20
15
10
8
6
4
3
2
1
1 2 3 4 5
5 10 15 20 30 40 m
3
/h
10 15 l/s
m m 8 1 6 5 , 3 Valve spacing
F 100 Thermo
018
5.0
23
5.0
00
1_R
LF
.2
_09
.10
_D
S
W
09.
10_E
S