Mahlkonig E80 GbW, Operating Manual, Page: 28 / 47

Changing the coffee bean type
1. Close the bean hopper
(1)
by sliding in the funnel slide
(18)
.
2. Grind any coffee beans left in the grinding mechanism until the grinder
runs empty.
3. Use a slot screwdriver to undo the securing screw
(19)
for the bean
hopper.
4. Rotate the bean hopper anticlockwise to release it from the grinder and
lift it upwards to remove it from the grinder.
5. Remove the remaining coffee beans from the bean hopper.
6. Remove any excess beans from the bean hopper intake
(2)
(see
Fig. B
).
7. Place the bean hopper on the bean hopper intake.
When placing the bean hopper, make sure to place the nose of the bean
hopper in the corresponding recess of the bean hopper intake.
8. Push the bean hopper down into the bean hopper intake and turn the
bean hopper clockwise to fix it to the grinder.
If the bean hopper cannot be fixed in place by turning it, it may not be
positioned correctly. In this case, align the bean hopper correctly
(see step 8) and then try again by pressing it down and turning it
(see also the chapter on “Troubleshooting”).
9. Use a slot screwdriver to tighten the securing screw for the bean hopper
clockwise.
10. Fill the bean hopper with the new coffee beans.
11. Open the bean hopper by pulling out the hopper slide.
12. Grind 2–3 shots to remove any residue of the old coffee beans, to warm
up the machine and to avoid any fluctuations in the dosage.
E80 GbW | F80 GbW | EN ESPRESSO GRINDER| FILTER COFFEE GRINDER
28