© Copyright Mahindra and Mahindra Ltd. 012020
18-11
1
18
8..5
5..6
6 C
Ch
he
ec
ckkiin
ng
g/
/T
To
op
pp
piin
ng
g B
Brra
akke
e/
/C
Cllu
uttc
ch
h F
Fllu
uiid
d
The brake and clutch systems are supplied fluid from the same
reservoir.
The brake fluid level will drop slowly as the brakes wear, and will rise
when the brake components are replaced. Fluid levels between the
“MIN” and “MAX” lines are within the normal operating range; there
is no need to add fluid. If the fluid levels are below the “MIN” mark,
the performance of the systems could be compromised; the brake/
clutch operation could be spongy and gear change harder. Top-up
the recommended brake/clutch fluid till the “MAX” mark or contact
an Authorised Mahindra Dealer immediately.
Carefully clean the cap on the reservoir before you remove it and be
sure no debris fall in the reservoir. Do not keep the reservoir open
for longer than necessary to add brake fluid.
Use only brake/clutch fluid that meets Mahindra specifications.
Refer to ‘Lubricant and Capacities’ section.
Draining or changing of brake fluid should always be done by an
Authorised Mahindra Dealer.
1
18
8..5
5..7
7 W
Wiin
nd
dssh
hiie
elld
d W
Wa
assh
he
err F
Fllu
uiid
d T
To
op
p--u
up
p
Top-up windshield washer reservoirs as and when required.
The windshield washer tank is located next to the right side head
lamp in the engine bay. It supplies fluid to both front and rear
washer.
In very cold weather conditions, fill the reservoir with washer fluid
premixed with anti-freeze.
M
MA
AIIN
NT
TE
EN
NA
AN
NC
CE
E