BA322301-en
33
4.6.2
Installation Frame for Flat Head Lifts
CAUTION
In this installation situation, there is no floor compensation; when raised, this
results in additional tripping hazards. This must be observed when working on
the vehicle.
4.6.3
Wheel Engaging Support
Lifts with a nominal load capacity of 4500 kg and above can be equipped with
wheel engaging supports as an alternative to the disc supports.
The lift is designed according to EN 1493, which specifies a total load capacity
and takes into account an asymmetrical load distribution. When using the wheel
engaging supports, it should be noted that the vehicle weight with asymmetrical
load distribution is no longer decisive, but the individual load-bearing capacity
of 1,000 kg per wheel engaging support:
•
Maximum wheel load 1000 kg
For the conversion, remove the threaded sleeves and install the wheel engaging
supports as shown below.
A
Guide plate
D
Threaded sleeve
B
Support pin
E
Wheel engaging fork
C
Fastening screws M12x45 10.9
F
Fastening screw with washer
F
D
E
A
B
C
Summary of Contents for ZS SQUARE II 3.5
Page 16: ...16 BA322301 en 2 4 3 Set up Diagrams...
Page 32: ...32 BA322301 en B B 3 4 B C 5...
Page 52: ...20 PL670000_002 de...
