30
BA322301-en
4.5.2
Mechanical Emergency Lowering
The mechanical emergency lowering takes place via the bleeding blocks of the
lifting units.
1 Remove the centre cover and store it outside the danger zone (see section
“Danger zone”
.
WARNING
The lift can/will lower on one side when the respective lowering valves are
opened (tilt on one side approx. 50 mm).
Leave the danger zone directly after opening the second lowering valve!
2 Slightly open lowering valve
+C-M2.A
(turn knurled screw on the valve in a
counterclockwise direction)
→
lifting unit
+A
begins to lower.
3 Immediately continue by slightly opening lowering valve
+C-M2.B
(turn
knurled screw on the valve in a counterclockwise direction)
→
lifting unit
+A
begins to lower. Leave the danger zone directly.
4 Once the lift is completely lowered, slowly drive off the vehicle.
5 The lowering valves must now be closed again (turn knurled screw on the
valve in a clockwise direction).
6 Place the centre cover back on the installation box.
+C-M2.A
+C-M2.B
E
F
Summary of Contents for ZS SQUARE II 3.5
Page 16: ...16 BA322301 en 2 4 3 Set up Diagrams...
Page 32: ...32 BA322301 en B B 3 4 B C 5...
Page 52: ...20 PL670000_002 de...
