150331_IOM_GS_PE-LMD_BASIKA_rho_gb
8 von 30
Depending on the construction, as an option and for easy cleaning purposes the
separators are either equipped with a suction pipe leaving the container at the bottom and
leading to the top (up to the container upper rim) and a flange PN 10 at the end. In addition
the grease separators are equipped with a screw connection to connect a filling unit if
required later-on.
4.1 Design Alternatives
4.1.1 Manual semi-automatic disposal device
The separator can be supplied with the following options: inspection window; agitator(s)
allowing that the hardened grease layers as well as the settled sludge become a
homogeneous slurry which is easy to be sucked off from the disposal car without opening
the lid; filling unit, solenoid valve to refill the separator, signalling unit “max. grease storage
capacity reached”.
4.1.2 Fully Automatic Disposal Device
Equipped with inspection window, agitator(s), filling unit with solenoid valve to refill the
separator automatically, pressure sensor to monitor the level and disposal pump.
5.
Set- up and Installation
An authorized and competent company has to do the installation.
Any national prescriptions regarding prevention of accidents as well as existing
internal occupational and safety prescriptions need to be followed.
First of all check whether all parts of the plant were supplied and whether these are
in perfect condition (never assemble any defective parts).
5.1 Choice of Set-up Area
•
Separators should be set-up close to the area where the waste water is produced. In
addition the suction connection for disposal vehicles should be easily accessible
(excerpt DIN EN 1825-2).