13
OPERA
TION
4. Manually Controlled Operation
Note:
Using the 6400 without a personal computer will limit its testing
capabilities.
4.1
SETTING DESIRED OPERATING PARAMETERS
Note:
See Appendix B: Front Panel/Display Menu Flow Charts.
4.1.1
P
OWER
U
NITS
S
ETUP
Selects the desired unit of power (watts, hp, kW) that corresponds with the values displayed, or
selects the auxiliary input (AUX) to be displayed.
1. Press and release SHIFT.
2. Press and release POWER UNITS button. The display appears as follows:
POWER/AUX
TORQUE
SPEED
POWER UNITS SELECTION
Figure 4–1 Power Units Setup Menu
3. Use UP
S
and DOWN
T
buttons until the desired unit of power is displayed.
4. Press and release SHIFT to make selection and return to main menu.
4.1.2
T
ORQUE
U
NITS
S
ETUP
Selects the desired unit of measure (oz·in, oz·ft, lb·in, lb·ft, g·cm, kg·cm, Nmm, Ncm, Nm or kNm)
that corresponds with the values displayed.
1. Press and release SHIFT.
2. Press and release TORQUE UNITS button. The display appears as follows:
POWER/AUX
TORQUE
SPEED
TORQUE UNITS SELECTION
Figure 4–2 Torque Units Setup Menu
3. Use UP
S
and DOWN
T
buttons until the desired unit of measure is displayed.
4. Press and release SHIFT to make selection and return to main menu.