10
SETUP
3. Installation/Configuration
Note:
Before installing the 6400, you should become familiar with the
front and rear panels, as outlined in Chapter 2–Controls.
3.1
POWERING UP THE 6400
WARNING!
TO REDUCE THE RISK OF ELECTRIC SHOCK, MAKE
SURE THE 6400 IS EARTH GROUNDED BEFORE
STARTING!
3.1.1
S
ETTING
U
NIT
FOR
L
INE
V
OLTAGE
The 6400 will operate with either of the following power sources:
•
120 V 50/60 Hz
•
240 V 50/60 Hz
1. Find the line cord receptacle on the rear panel. The line cord is a detachable NEMA Standard
3-wire.
2. If changing the line voltage:
1) Locate the power entry module.
2) Remove the line cord.
3) Insert a screwdriver into the slot and open the fuse door.
4) Install the appropriate fuses for that voltage as marked on the rear panel of the unit.
3.1.2
S
ELF
-T
EST
Note:
To make sure that the 6400 is operational, a Magtrol torque sensor
must be installed and connected to the 6400. It is not required that
the 6400 be connected to a computer.
1. Connect the 6400 to the torque transducer using a 14-pin to 6-pin signal cable.
STOP
STOP