17
Magtrol Model 3411 Torque Display
Chapter 4 – Manually Controlled Operation
OPERA
TION
4.1.5.7
TM Invert Setup
1. Press the SYSTEM SETUP button.
2. Press the UP/DOWN arrow buttons until TM INVERT shows in the display.
3. Press ENTER to go to the TM invert setup menu. The display will appear as follows:
POWER
TORQUE
SPEED
XXX
Figure 4–11 TM Invert Setup
4. Press the UP/DOWN arrow buttons until the desired TM invert selection appears in the
display.
5. Press ENTER to save and return to the Default Display.
4.1.6
t
are
B
utton
The torque offset voltage may be changed using the tare button. The torque input voltage when tare
is activated will be used as an offset and the torque reading will go to zero.
1. Press TARE button.
2. The red LED will turn on to indicate the tare function is active.
4.1.7
r
eSet
t
are
B
utton
Used to reset any tare offset voltage back to the original calibrated setting.
1. Press the RESET TARE button.
NOTE:
Pressing RESET TARE while tare is not active will have no effect.