5 - Removal and Re-installation
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 207 of 356 (
D99875607-91
)
5.20
How to Remove / Re-install the XY Transport Ribbon Cable
Approximate time to remove: 5 minutes plus any sub-procedures
Approximate time to re-install: 5 minutes plus any sub-procedures
Figure 5-70 - XY Transport Showing Ribbon Cable (FRONT VIEW)
Some of the modules inside the ExpressCard you are servicing may look different from
the photos in this procedure. However, the steps of the procedure are the same, and are
unrelated to / unaffected by the appearance of the modules.
This section provides information for replacing just the XY transport ribbon cable, which occasionally
must be replaced without replacing the entire module. For instructions on removing and re-installing the
entire XY transport module, see section
5.19 How to Remove / Re-install the XY Transport
