Magtek EXPRESSCARD 1000, Hardware Service Manual

Page: 80 / 194

Section 4: Removal and Replacement
73
Setting the Print EOF
This procedure positions the printed image correctly on the trailing edge of the card.
Step Procedure
1. Choose
Menu> Printer> Menu
from the LCD display,
Print Test Image
and the correct
ribbon type to print a test card (remember to press select).
2. Select
Setup Printer
,
Print Settings
and
Print EOF
.
3. Record the Print EOF value on the test card you just printed.
a. Examine the test card.
b. If the test card does not look like the sample shown below, go to Print EOF.
4. Decrease the Print EOF value to move the printed image more toward the leading edge
of the card. OR Increase the Print EOF value to move the printed image more toward
the trailing edge of the card.
Note
: The numbers being entered for the settings are in ½ pixels. The number of pixels
is equal to the measurement in inches times 600 or the measurement in mm times 23.6.
(For example, 0.100 inches or 2.54mm equals 60 increments on the LCD.)
5. Press
DONE
to save the value. Press
YES
when asked to save the change. Print a test
card as described in step 1.
6. Repeat
Step
s 1 to 6 (above) until the Test Image is correctly positioned.